AUTO LIGHT/WIPER CONTROL MODULE REMOVAL/INSTALLATION

id091800809400

1.  Disconnect the negative battery cable.

2.  Remove the following parts:

(1)  Glove compartment (See GLOVE COMPARTMENT REMOVAL/INSTALLATION.)

(2)  Upper panel (See UPPER PANEL REMOVAL/INSTALLATION.)

(3)  Shift panel (See SHIFT PANEL REMOVAL/INSTALLATION.)

(4)  Center panel lower (See CENTER PANEL LOWER REMOVAL/INSTALLATION.)

(5)  Decoration panel (See DECORATION PANEL REMOVAL/INSTALLATION.)

(6)  Rear console (See REAR CONSOLE REMOVAL/INSTALLATION.)

3.  Remove the nut shown in the figure.

am6zzw00002142

4.  Remove the detached auto light/wiper control module in the direction of the arrow shown in the figure.

5.  Disconnect the auto light/wiper control module connector.

am6zzw00002143

6.  Install in the reverse order of removal.