AUXILIARY JACK INSPECTION
id092000812600
1. Disconnect the negative battery cable.
2. Remove the following parts:
- (1) Upper panel (See UPPER PANEL REMOVAL/INSTALLATION.)
- (2) Shift knob (MTX) (See MANUAL TRANSAXLE SHIFT MECHANISM REMOVAL/INSTALLATION.)
- (3) Shift panel (See SHIFT PANEL REMOVAL/INSTALLATION.)
- (4) Decoration panel (See DECORATION PANEL REMOVAL/INSTALLATION.)
- (5) Center panel lower (See CENTER PANEL LOWER REMOVAL/INSTALLATION.)
- (6) Rear console (See REAR CONSOLE REMOVAL/INSTALLATION.)
- (7) Auxiliary jack (See AUXILIARY JACK REMOVAL/INSTALLATION.)
3. Connect a commercially-available nonresistant plug to the auxiliary jack.
4. Verify that the continuity between the auxiliary jack terminals is as indicated in the table.
-
• If not as indicated in the table, replace the auxiliary jack.
