BATTERY REMOVAL/INSTALLATION [13B-MSP]

id0117f2800500

Warning

•  For vehicles with DSC, if the negative battery cable is disconnected, the stored initial position of the steering angle sensor will be cleared and the DSC will not operate properly, making the vehicle unsafe to drive. Perform the steering angle sensor initialization procedure after connecting the negative battery cable.

1.  Remove the engine cover. (See ENGINE COVER REMOVAL/INSTALLATION [13B-MSP].)

2.  Remove in the order indicated in the table.

3.  Install in the reverse order of removal.

4.  Perform the steering angle sensor initialization procedure. (See STEERING ANGLE SENSOR INITIALIZATION PROCEDURE.)

ar8wzw00000785

1	Battery cover (See Battery Cover Removal Note.)
2	Negative battery cable (See Negative Battery Cable Installation Note.)
3	Positive battery cable
4	Battery clamp
5	Battery
6	Battery box (See Battery Box Removal Note.)
7	Battery tray
8	Battery duct (See Battery Duct Removal Note.)

Battery Cover Removal Note

1.  Pull up the two tabs on the rear, remove the two tabs on the front, and then remove the battery cover.

ar8wzw00000786

Battery Box Removal Note

1.  Lightly press the battery box from inside to outside to detach it from the battery tray tabs.

ar8wzw00000787

2.  Remove the battery box.

Battery Duct Removal Note

1.  Remove the aerodynamic under cover (See AERODYNAMIC UNDER COVER REMOVAL/INSTALLATION.)

2.  Remove the two clips which secure the battery duct to the radiator cowling.

3.  Remove the battery duct.

Negative Battery Cable Installation Note

1.  When connecting the negative battery cable to the battery, connect the negative battery cable as shown in the figure.

ar8wzw00000788