ECCENTRIC SHAFT POSITION SENSOR INSPECTION [13B-MSP]

id0140g1808700

Visual Inspection

1.  Remove the eccentric shaft position sensor.

2.  Verify that there are no metal shavings on the sensor.

•  If the monitor item condition (reference) is not within the specification, repair or replace the eccentric shaft position sensor. (See ECCENTRIC SHAFT POSITION SENSOR REMOVAL/INSTALLATION [13B-MSP].)

Resistance Inspection

1.  Disconnect the eccentric shaft position sensor connector.

2.  Measure the coil resistance between eccentric shaft position sensor terminals A and B.

•  If not within the specification, replace the eccentric shaft position sensor. (See ECCENTRIC SHAFT POSITION SENSOR REMOVAL/INSTALLATION [13B-MSP].)