ECCENTRIC SHAFT POSITION SENSOR REMOVAL/INSTALLATION [13B-MSP]

id0140g1808800

Caution

•  When replacing the eccentric shaft position sensor, make sure there is no foreign material on it such as metal shavings. If it is installed with foreign material, the sensor output signal will malfunction resulting from fluctuation in magnetic flux and cause a deterioration in engine control.

Note

•  Remove/install the eccentric shaft position sensor from above the vehicle.

1.  Remove the battery cover. (See BATTERY REMOVAL/INSTALLATION [13B-MSP].)

2.  Disconnect the negative battery cable. (See BATTERY REMOVAL/INSTALLATION [13B-MSP].)

3.  Remove the air cleaner component and air cleaner insulator. (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION [13B-MSP].)

4.  Disconnect the eccentric shaft position sensor connector.

5.  Remove the eccentric shaft position sensor installation bolt and remove the eccentric shaft position sensor.

ar8wzw00001493

6.  Install in the reverse order of removal.