OIL SEAL (EXTENSION HOUSING) REPLACEMENT [SJ6A-EL]

id051311710000

1.  Remove the engine cover. (See ENGINE COVER REMOVAL/INSTALLATION [13B-MSP].)

2.  Remove the battery cover.

3.  Disconnect the negative battery cable.

4.  Clean the transmission exterior thoroughly using a steam cleaner or cleaning solvent.

5.  Remove the following parts.

(1)  Front tunnel member

(2)  Rear tunnel member

(3)  Catalytic converter (See EXHAUST SYSTEM REMOVAL/INSTALLATION [13B-MSP].)

(4)  Power plant frame

(5)  Propeller shaft (See PROPELLER SHAFT REMOVAL/INSTALLATION.)

Caution

•  Do not to damage the extension dust deflector.

•  Do not to damage the extension housing.

6.  Using a plastic hammer and slab of wood, tap the extension dust deflector to remove it.

ar8jjw00001011

7.  Using a tape-wrapped flathead screwdriver, remove the extension housing shroud.

ar8jjw00001012

8.  Using a tape-wrapped flathead screwdriver, remove the oil seal.

ar8jjw00001013

9.  Using the SST and a hammer, install the new oil seal to the extension housing.

e5u513zw5044

10.  Coat the oil seal lip with grease.

11.  Using the SST and a hammer, install the new extension housing shroud to the extension housing.

e5u513zw5043

12.  Using a hammer and slab of wood, install the extension dust deflector to the extension housing.

ar8uuw00002547

13.  Install the following parts.

(1)  Propeller shaft (See PROPELLER SHAFT REMOVAL/INSTALLATION.)

(2)  Power plant frame

(3)  Catalytic converter (See EXHAUST SYSTEM REMOVAL/INSTALLATION [13B-MSP].)

(4)  Rear tunnel member

(5)  Front tunnel member

14.  Inspect the ATF level. (See AUTOMATIC TRANSMISSION FLUID (ATF) INSPECTION [SJ6A-EL].)

15.  Connect the negative battery cable.

16.  Install the battery cover.

17.  Install the engine cover. (See ENGINE COVER REMOVAL/INSTALLATION [13B-MSP].)