WINDSHIELD REMOVAL

id091200801300

1. Remove the following parts:

2. Set the headliner out of the way.

3. Apply protective tape along the edge of the body.

4. Apply protective tape to the dashboard to protect it from damage.

5. Cut the windshield molding lip using a razor.

ar8uuw00000664

Warning

• Using a razor with bare hands can cause injury. Always wear gloves when using a razor.

Note

• The windshield molding is a replacement part.

Not Reusing Windshield

Note

• For the areas of the sealant that are difficult to cut, use the piano wire and follow the procedure under “Reusing Windshield”.

1. Remove the base. (See BASE REMOVAL.)

2. Cut out the sealant all around the glass using a sealant remover.

ar8uuw00000665

3. Remove the sealant by pulling it off.

4. Remove the windshield.

Reusing Windshield

Note

• Before removing the windshield from the body, mark the position of the windshield by affixing tape to the windshield and body panel.

1. Make a hole through the sealant from the inside of the vehicle using an awl, avoiding the pins.

ar8uuw00000666

2. Pass the piano wire, cut to sufficient length, through the hole.

ar8uuw00000667

Warning

• Using the piano wire with bare hands can cause injury. Always wear gloves when using the piano wire.

3. Wind each end of the piano wire around a bar.

Note

• Use a long sawing action to spread the work over the whole length of the piano wire to prevent it from breaking due to localized heating.

4. Fix one end of the piano wire, and while pulling the other end, cut the sealant around the windshield.

ar8uuw00000668

Note

• As the upper part of the pin adheres to the sealant, cut it using the piano wire.

5. Cut the pins out.

ar8uuw00000669

6. Remove the windshield.

7. Mark the seating positions of the pins and remove the pins from the windshield.

8. Remove the windshield molding from the windshield.