HEADLIGHT CLEANER RELAY INSPECTION
id091900805600
1. Remove the headlight cleaner relay with the connector still connected.
2. Measure the voltage at each terminal (other than terminal F).
3. Disconnect the negative battery cable.
4. Verify that continuity at terminal F is as indicated in the Terminal Voltage Table (Reference).
Terminal Voltage Table (Reference)
chu0919w123
|
Terminal |
Signal name |
Connected to |
Measured condition |
Voltage (V)/Continuity |
Inspection item(s) |
|
---|---|---|---|---|---|---|
A
|
Headlight cleaner motor output
|
Headlight cleaner motor
|
Headlight cleaner activated (auto-operation or manual operation activated)
|
Alternates between 1.0 or less and B+
|
• Headlight relay
(See RELAY INSPECTION.)
• Windshield wiper and washer switch (See WINDSHIELD WIPER AND WASHER SWITCH INSPECTION.)
• Headlight cleaner motor (See HEADLIGHT CLEANER MOTOR INSPECTION.)
• Related wiring harnesses
|
|
Except above
|
B+
|
|||||
D
|
Windshield washer motor output
|
Windshield wiper and washer switch
|
Turn the ignition switch to the ON position.
|
Turn the washer switch to the OFF position.
|
1.0 or less
|
• Headlight relay
(See RELAY INSPECTION.)
• Windshield wiper and washer switch (See WINDSHIELD WIPER AND WASHER SWITCH INSPECTION.)
• Related wiring harnesses
|
Turn the washer switch to the ON position.
|
B+
|
|||||
E
|
Headlight
|
Headlight relay
|
Light switch at ON position.
|
B+
|
• Headlight relay
(See RELAY INSPECTION.)
• Related wiring harnesses
|
|
Except above
|
1.0 or less
|
|||||
F
|
GND
|
Body ground
|
Under any condition: Inspect for continuity to ground.
|
Continuity detected
|
• GND
• Related wiring harnesses
|