ANTENNA FEEDER NO.2 INSPECTION
id092000812500
1. Disconnect the negative battery cable.
2. Remove the following parts:
- (1) Inner scuff plate (LH) (See INNER SCUFF PLATE REMOVAL/INSTALLATION.)
- (2) Front side trim (LH) (See FRONT SIDE TRIM REMOVAL/INSTALLATION.)
- (3) Rear seat (LH) (See REAR SEAT REMOVAL/INSTALLATION.)
- (4) Tire house trim (LH) (See TIRE HOUSE TRIM REMOVAL/INSTALLATION.)
- (5) Rear pillar trim (LH) (See REAR PILLAR TRIM REMOVAL/INSTALLATION.)
3. Remove the fasteners, then slightly bend back the headliner.
4. Verify that the continuity is as indicated in the table.
-
• If not as indicated in the table, replace the antenna feeder No.2.
