DTC P0761

id050200808700

DTC P0761

Shift solenoid B malfunction (stuck off)

DETECTION CONDITION

•  Large difference between actual gear ratio and gear ratio set in TCM.

Diagnostic support note:

•  This is a continuous monitor (CCM).

•  MIL illuminates if TCM detects the above malfunction conditions in two consecutive drive cycles.

•  PENDING CODE is available.

•  FREEZE FRAME DATA is available.

•  AT warning light does not illuminate.

•  DTC is stored in TCM memory.

POSSIBLE CAUSE

•  Shift solenoid B malfunction

•  Shift valve B stuck

•  TCM malfunction

DTC P0761	Shift solenoid B malfunction (stuck off)
DETECTION CONDITION	• Large difference between actual gear ratio and gear ratio set in TCM. Diagnostic support note: • This is a continuous monitor (CCM). • MIL illuminates if TCM detects the above malfunction conditions in two consecutive drive cycles. • PENDING CODE is available. • FREEZE FRAME DATA is available. • AT warning light does not illuminate. • DTC is stored in TCM memory.
POSSIBLE CAUSE	• Shift solenoid B malfunction • Shift valve B stuck • TCM malfunction

Diagnostic procedure

STEP	INSPECTION		ACTION
1	VERIFY FREEZE FRAME DATA HAS BEEN RECORDED • Has FREEZE FRAME DATA been recorded?	Yes	Go to the next step.
1		No	Record the FREEZE FRAME DATA on the repair order, then go to the next step.
2	VERIFY RELATED REPAIR INFORMATION AVAILABILITY • Verify related Service Information availability. • Is any related repair information available?	Yes	Perform repair or diagnosis according to the available repair information. • If the vehicle is not repaired, go to the next step.
2		No	Go to the next step.
3	INSPECT FOR DTC • Turn the ignition switch to the ON position (engine off). • Inspect for DTCs. • Are any other DTCs output?	Yes	Follow the applicable DTC inspection procedure, then go to the next step. (See DTC TABLE [RC4A-EL].)
3		No	Go to the next step.
4	INSPECT ATF CONDITION • Turn the ignition switch to the LOCK position. • Inspect ATF condition. ― Transparent red: Normal ― Milky: Water mixed in fluid ― Reddish brown: Deteriorated ATF • Is it normal? (See AUTOMATIC TRANSMISSION FLUID (ATF) INSPECTION.)	Yes	Replace the control valve body, then go to the next step. (See CONTROL VALVE BODY REMOVAL.) (See CONTROL VALVE BODY INSTALLATION.)
4		No	If the ATF color milky or reddish brown, repair or replace AT, then go to the next step.
5	VERIFY TROUBLESHOOTING OF DTC P0761 COMPLETED • Make sure to reconnect all disconnected connectors. • Clear the DTC from the TCM memory using the M-MDS. • Start the engine. • Warm up AT. • Drive the vehicle in D range and make sure that the gears shift smoothly from 1GR to 4GR. • Is the PENDING CODE same as the DTC present?	Yes	Replace the TCM, then go to the next step. (See TCM REMOVAL/INSTALLATION.)
5		No	Go to the next step.
6	VERIFY AFTER REPAIR PROCEDURE • Perform the “After Repair Procedure”. (See AFTER REPAIR PROCEDURE [RC4A-EL].) • Are any DTCs present?	Yes	Go to the applicable DTC inspection. (See DTC TABLE [RC4A-EL].)
6		No	DTC troubleshooting completed.