CYLINDER HEAD COVER (RH) REMOVAL/INSTALLATION[AJ (3.0L Duratec)]

id0110a3802700

Removal

2. Remove the ignition coil (RH).

atraaw00000370

(1) Disconnect the three electrical connectors.

(2) Remove the three bolts.

(3) Remove the ignition coil.

3. Remove the wiring harness nuts and disconnect the HO2S connectors.

atraaw00000371

4. Disconnect the condenser.

atraaw00000372

5. Disconnect the PCV hose from the cylinder head cover.

6. Remove the cylinder head cover bolts and studs in the order shown.

atraaw00000730

Installation

1. Install a new cylinder head cover gasket.

2. Apply a 8 mm {0.32 in} dot of silicone sealant to the front cover to cylinder head joints.

atraaw00000731

Note

• The cylinder head cover must be installed and the bolts tightened within six minutes of applying the sealant.

3. Position the cylinder head cover and install the bolt and the studs in the sequence shown.

atraaw00000732

4. Connect the PCV hose to the cylinder head cover.

5. Connect the condenser.

atraaw00000372

6. Connect the HO2S connectors and wiring harness to the RH cylinder head cover stud.

atraaw00000371

7. Install the ignition coils (RH).

atraaw00000996

(1) Position the ignition coils.

(2) Install the three bolts.

(3) Connect the connector.