DTC B1676[AJ (3.0L Duratec)]
id040242802500
DTC
|
B1676
|
Battery voltage
|
|
MALFUNCTION
|
• Battery voltage is out of specification.
|
Diagnostic Procedure
STEP |
INSPECTION |
ACTION |
|
---|---|---|---|
1
|
INSPECT VEHICLE CONDITION
• Has the vehicle been towed with wheels not on the ground within the past two weeks?
|
Yes
|
• Clear the DTC from the memory and perform the self-test.
|
No
|
• Go to the next step.
|
||
2
|
INSPECT BATTERY VOLTAGE
• Measure the voltage between the battery positive terminal and negative terminal.
• Is the voltage between 9—19 V?
|
Yes
|
• Go to the next step.
|
No
|
• Charge or replace the battery. Clear the DTC from the memory and perform the self-test.
|
||
3
|
INSPECT CHARGING SYSTEM
• Start the engine and idle it at 2,000 rpm, and measure the voltage between the battery positive terminal and negative terminal.
• Is the voltage between 9—19 V?
|
Yes
|
• Go to the next step.
|
No
|
• Repair the charging system. Clear the DTC from the memory and perform the self-test.
|
||
4
|
INSPECT ABS HU/CM TERMINAL O VOLTAGE
• Turn the ignition switch off.
• Disconnect the ABS HU/CM connectors.
• Measure the voltage between the ABS HU/CM terminal and ground.
• Is the voltage more than 10 V?
|
Yes
|
• Go to the next step.
|
No
|
• Repair or replace the wiring harness and clear the DTC from the memory. Repeat the self-test.
|
||
5
|
INSPECT ABS HU/CM TERMINAL C VOLTAGE
• Turn the ignition switch off.
• Measure the voltage between the ABS HU/CM terminal A and ground.
• Is the voltage more than 10 V?
|
Yes
|
• Go to the next step.
|
No
|
• Repair or replace the wiring harness and clear the DTC from the memory. Repeat the self-test.
|
||
6
|
INSPECT ABS HU/CM TERMINAL B VOLTAGE
• Measure the voltage between the ABS HU/CM terminal B and ground.
• Is the voltage more than 10 V?
|
Yes
|
• Go to the next step.
|
No
|
• Repair or replace the wiring harness and clear the DTC from the memory. Repeat the self-test.
|
||
7
|
INSPECT ABS HU/CM TERMINAL C AND D FOR OPEN CIRCUIT
• Measure the resistance between the ABS HU/CM terminal C and ground, and between ABS HU/CM terminal D and ground.
• Is the resistance less than 5 ohms?
|
Yes
|
• Replace the ABS HU/CM.
(See ABS CM REMOVAL/INSTALLATION.)
Clear the DTC from the memory. Repeat the self-test.
|
No
|
• Repair or replace the wiring harness and clear the DTC from the memory. Repeat the self-test.
|