DTC P1742, P1744[LA4AX-EL (CD4E)]


id050207807400

DTC P1742

Torque converter clutch solenoid malfunction

DTC P1744

Abnormal lock-up (slipping)

DETECTION CONDITION
•  P1742: PCM detects malfunction in electrical, mechanical, or oil pressure system of torque converter clutch solenoid
•  P1744: PCM detects slipping during full engagement of torque converter clutch
POSSIBLE CAUSE
•  TCC solenoid malfunction
•  TCC malfunction
•  Transaxle internal malfunction
•  PCM malfunction

Diagnostic procedure

STEP

INSPECTION

ACTION

1
VERIFY RELATED SERVICE INFORMATION AVAILABILITY
•  Verify related Service Information availability.
•  Is any related Service Information available?
Yes
Perform repair or diagnosis according to the available Service Information.
•  If the vehicle is not repaired, go to the next step.
No
Go to the next step.
2
VERIFY DTCS
•  Turn the ignition switch to the LOCK position, then to the ON position.
•  Verify the DTCs in the PCM memory.
•  Are except DTCs P1742 and P1744 output?
Yes
Go to the applicable DTC inspection.
No
Go to the next step.
3
TORQUE CONVERTER CLUTCH SOLENOID OPERATION INSPECTION
•  Connect the M-MDS to the DLC-2 and select the TCC PID.
•  Using the M-MDS, verify the operation status of the torque converter clutch solenoid while driving the vehicle.
•  Is the operation of the torque converter clutch solenoid normal?
Yes
Replace the torque converter, then go to the next step.
No
Replace the solenoid body assembly, then go to the next step.
4
VERIFY TROUBLESHOOTING OF DTC P1742 OR P1744 COMPLETED
•  Make sure to reconnect all the disconnected connectors.
•  Clear the DTC using the M-MDS.
•  Perform the “After Repair Procedure”.
•  Are any DTCs present?
Yes
Replace the PCM, then go to the next step.
No
Go to the next step.
5
VERIFY DTCS
•  Are except DTCs P1742 and P1744 output?
Yes
Go to the applicable DTC inspection.
No
DTC troubleshooting completed.