CONTROL VALVE BODY REMOVAL/INSTALLATION[GF4AX-EL]

id051703801800


On‐Vehicle Removal

Warning
•  A hot transaxle and ATF can cause severe burns. Turn off the engine and wait until they are cool before removing the control valve body.
•  Using compressed air can cause dirt and other particles to fly out, causing injury to the eyes. Wear protective eyeglasses whenever using compressed air.
Caution
•  Clean the transaxle exterior throughout with a stream cleaner or cleaning solvents before removal.
•  If any old sealant gets into the transaxle during installation of the oil pan, trouble may occur in the transaxle case and oil pan, and clean with cleaning fluids.

1.  Clean the transaxle exterior thoroughly with a steam cleaner or cleaning solvents.

2.  Disconnect the negative battery cable.

3.  Remove the battery and battery tray.

4.  Remove the splash shield (LH).

5.  Drain the ATF. (See AUTOMATIC TRANSAXLE FLUID (ATF) REPLACEMENT[GF4AX-EL].)

6.  Remove the oil cooler hose. (See OIL COOLER REMOVAL/INSTALLATION[GF4AX-EL].)

7.  Remove the control valve body cover.

atraaw00002039

8.  Disconnect the solenoid valve connectors and TFT sensor connector.

atraaw00002040

9.  Remove the control valve body component.

atraaw00002041


On‐Vehicle Installation

1.  Align the manual plate and the manual valve.

atraaw00002042

2.  Install the control valve body component.

atraaw00002041

Tightening torque
11.0—15.0 N·m {1.2—1.5 kgf·m, 8.2—11.0 ft·lbf}

3.  Match the harness colors and connect the solenoid connectors and TFT sensor connector.

4.  Apply a light coat of silicon sealant to the contact surfaces of the oil pan and transaxle case.

5.  Install the control valve body cover.

atraaw00002039

Tightening torque
8.34—10.8 N·m {85—110 kgf·cm, 73.7—95.4 in·lbf}

6.  Install the oil cooler hose. (See OIL COOLER REMOVAL/INSTALLATION[GF4AX-EL].)

7.  Install the splash shield (LH).

8.  Install the battery tray and battery.

9.  Connect the negative battery cable.

10.  Add ATF to the specified level. (See AUTOMATIC TRANSAXLE FLUID (ATF) REPLACEMENT[GF4AX-EL].)

11.  Inspect for leakage of ATF from the control valve body cover or the oil hose connecting points.

12.  Perform the mechanical system test. (See MECHANICAL SYSTEM TEST[GF4AX-EL].)