DTC P0507 [AJ (3.0L Duratec)]


id0102a4808700

DTC P0507

IAC underspeed error

DETECTION CONDITION

• This DTC is set when the PCM detects engine idle speed that is less than the desired rpm.

POSSIBLE CAUSE

• IAC valve malfunction
• Accelerator cable misadjusting
• Actuator cable misadjusting
• Throttle valve malfunction
• Vacuum hose misconnection
• PCM malfunction

Diagnostic procedure

STEP

INSPECTION

ACTION

1
VERIFY FREEZE FRAME DATA HAS BEEN RECORDED
• Has FREEZE FRAME DATA been recorded?
Yes
Go to next step.
No
Record FREEZE FRAME DATA on repair order, then go to next step.
2
VERIFY RELATED REPAIR INFORMATION AVAILABILITY
• Check for related Service Bulletins and/or on-line repair information availability.
• Is any related repair information available?
Yes
Perform repair or diagnosis according to available repair information.
• If vehicle is not repaired, then go to next step.
No
Go to next step.
3
VERIFY RELATED PENDING OR STORED DTCS
• Turn ignition key to OFF, then ON (Engine OFF).
• Verify pending code or stored DTCs using WDS or equivalent.
• Is other DTC present?
Yes
Repair applicable DTCs.
No
Go to next step.
4
INSPECT IAC VALVE MALFUNCTION
• Perform IAC valve inspection.
• Is IAC valve okay?
Yes
Go to next step.
No
Replace IAC valve, then go to Step 9.
5
INSPECT ACCELERATOR CABLE FREE PLAY
• Turn ignition key to OFF.
• Is accelerator cable free play okay?
Yes
Go to next step.
No
Adjust accelerator cable free play, then go to Step 9.
6
INSPECT ACTUATOR CABLE FREE PLAY
• Is actuator cable adjustments okay?
Yes
Go to next step.
No
Adjust actuator cable free play, then go to Step 9.
7
INSPECT VACUUM HOSE CONNECTION
• Are vacuum hoses connecting accurately?
Yes
Go to next step.
No
Reconnect vacuum hose accurately, then go to step 9.
8
VISUAL INSPECT THROTTLE VALVE
• Remove throttle body.
• Is throttle valve fully closed?
Yes
Go to next step.
No
Clean or replace throttle body, then go to next step.
9
VERIFY TROUBLESHOOTING OF DTC P0507 COMPLETED
• Make sure to reconnect all disconnected connectors.
• Start engine.
• Clear DTC from PCM memory using WDS or equivalent.
• Is PENDING CODE for this DTC present?
Yes
Replace PCM, then go to next step.
No
Go to next step.
10
VERIFY AFTER SERVICE PROCEDURE
• Perform "AFTER SERVICE PROCEDURE".
• Is there any DTC present?
Yes
Go to applicable DTC inspection.
No
Troubleshooting completed.