PULSATION DAMPER REMOVAL/INSTALLATION [AJ (3.0L Duratec)]

id0114a1802900

1. Remove the dynamic chamber. (See DYNAMIC CHAMBER REMOVAL/INSTALLATION [AJ (3.0L Duratec)].)

2. Disconnect the vacuum hose.

3. Remove the snap ring.

4. Remove the pulsation damper.

Caution
• Since the general O-ring sealing could cause fuel leakage, always use genuine O-ring sealing.

5. Remove the O-ring sealing and replace with a new one.

• Apply a small amount of clean engine oil to the O-ring sealing.

6. Install in the reverse order of removal.