NO.2 VEHICLE MOVES IN N POSITION [GF4AX-EL]


2	Vehicle moves in N position
DESCRIPTION	• Vehicle creeps if brake pedal is not depressed in N position.
POSSIBLE CAUSE	• If the vehicle moves in N position, the malfunction is in the ATX. A malfunction in the sensor circuit or output circuit may cause of the ATX malfunction. Inspect the sensors, output circuit, and related wiring harnesses. 1. Clutch burnt (Forward clutch) • Line pressure low • Control valve body malfunction 2. Selector lever position disparity (Although the selector indicator shows N position, hydraulic circuit shows D range or R position) Note • Before following the troubleshooting steps, make sure that the Automatic Transaxle On-Board Diagnostic and Automatic Transaxle Basic Inspection are conducted.


STEP	INSPECTION		ACTION
1	Does the vehicle creep when the selector lever is moved slightly in N position?	Yes	Replace the control valve body. (See ATX Workshop Manual (GF4AX-EL)) If any problem remains, replace the transaxle and repair or replace any malfunctioning parts. (See AUTOMATIC TRANSAXLE AND TRANSFER REMOVAL/INSTALLATION [GF4AX-EL].)
1		No	Inspect and adjust the selector lever. (See SELECTOR LEVER INSPECTION.) (See SELECTOR CABLE ADJUSTMENT.)
2	• Verify the test results. - If normal, return to the diagnostic index to service any additional symptoms. - If the malfunction remains, inspect the related Service Information and perform repair or diagnosis. • If the vehicle is repaired, troubleshooting is completed. • If the vehicle is not repaired or additional diagnostic information is not available, replace the PCM.