INPUT/TURBINE SPEED SENSOR REMOVAL/INSTALLATION [GF4AX-EL]

1. Disconnect the negative battery cable.

2. Remove the battery and battery tray.

3. Remove the air cleaner component. (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION [L3].)

4. Disconnect the input/turbine speed sensor connector.

5. Remove the input/turbine speed sensor.

6. Apply ATF to a new O-ring and install it on an input/turbine speed sensor.

7. Install the input/turbine speed sensor.

Tightening torque

7.8-11.0 N·m {79-113 kgf·cm, 68.6-98.0 in·lbf}

8. Connect the input/turbine speed sensor connector.

9. Install the air cleaner component. (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION [L3].)

10. Install the battery tray and battery.

11. Connect the negative battery cable.