ANTENNA FEEDER REMOVAL/INSTALLATION

1. Remove the instrument cluster. (See INSTRUMENT CLUSTER REMOVAL/INSTALLATION.)

2. Disconnect the pin from the defroster resistor.

3. Remove the right lower A-pillar trim.

4. Disconnect the antenna cable connector.

5. Remove the side panel (RH).

6. Disconnect the pin-type retainer from the right vent duct.

7. Remove the audio unit. (See AUDIO UNIT REMOVAL.)

8. Disconnect the antenna cable.

(1) Release the pin-type retainer from the instrument panel support.

(2) Disconnect the antenna cable from the audio unit.

9. Pull the antenna cable out through the right instrument panel opening.

10. Install in the reverse order of removal.