AZ82.61-P-0001-02I Retrofit Traffic Star Radio and Navigation System

Retrofitting Traffic Star Radio And Navigation System

1. Position CAN bus adapter (5) in center of center console strut and mark holes (b).
2. Drill holes (b) with 6.2 mm dia. bit.

3. Fasten CAN bus adapter (5) to center console strut with two self-tapping screws (a) from parts kit.

NOTE: Screw screws through strut from below into CAN bus adapter mount.

4. Disconnect standard wiring harness (2) from transfer case control module (N78).
5. Connect CAN bus (9) wiring harness between transfer case control module (N78) and standard wiring harness (2).
6. Route CAN bus (6) lead on fan duct.

7. Route connector (8) for Traffic Star wiring harness (4) from radio shaft along fan duct to center console.

Steps 8 - 10 apply only for vehicles with manual transmission

8. Separate green lead (gn) from CAN bus adapter connector (8).
9. Tie Traffic Star (4) wiring harness on at height of shift gate and pull out green lead (gn).

10. Route green lead (gn) to back-up lamp switch (S16/2).
11. Connect lower gray lead (gr) from connector with assignment 2 for back-up lamp switch (S16/2) to green lead (gn) using solder connector.

NOTE: The connector for the back-up lamp switch (S16/2) has two gray leads, the lower of the two leads is for the switched back-up lamp signal.

12. Connect connector (8) and lead (6) to CAN bus adapter (5).
13. Install center console.

14. Connect brown and black wire (br, sw) from GPS antenna lead (3) with brown and black lead (br, sw) from Traffic Star wiring harness (4) and slide flat plug insulations together.
15. Attach flat plug connectors and GPS antenna lead (3) to Traffic Star wiring harness (4) with felt.

16. Install counter plug (7) from Traffic Star wiring harness (4) to radio connector (A2) and wrap with felt (c).

17. Connect radio connector (A) and GPS antenna connector (C3) with Traffic Star radio and navigation system (1).
18. Connect radio antenna.
19. Install Traffic Star (1) radio and navigation system.