Installation of Injection Pump (With Locking Screw)

INSTALLATION OF INJECTION PUMP (WITH LOCKING SCREW)

Adjusting value
Set engine to 15° after TDC of 1st cylinder

Special tools




Note: Remove injection pump.


Installation




1. Rotate engine in direction of rotation once and set to -15° after TDC of 1st cylinder.

Note: Clearances must be compensated.




2. Mount new gasket.

3. Lock injection pump. For this purpose, rotate pump shaft until 4th tooth on driver after tooth gap is in alignment with mark (arrows).




4. Slip in locking screw until there is a noticeable lock, turn camshaft slightly, if required.

Tighten coupling nut manually.




5. Slip coupling sleeve on driver.

6. Install injection pump, lighten.

7. Remove locking screw (arrow).