Model 126 With Engines 116.96/117.96
MODEL 126 WITH ENGINES 116.96/117.961. Remove/install fan shroud.
Remove/install fan viscous clutch and fan together with the fan shroud.
Tightening torque:
Collar bolts 25 Nm
2. Remove/install V-belts for power steering pump, generator, AC compressor and secondary air injection pump (SMS, Repair Instructions, Job no. 13-340).
3. Remove/install crankshaft pulley.
Tightening torque:
Crankshaft pulley hex bolts 35 Nm
4. Apply sealant/locker to fitting (arrow, Figure 9) and tap it into the lower vent bore of the coolant pump with a suitable mandrel.
5. Attach bracket (1, Figure 10) to the drainage pipe reservoir (3) with M8 hex bolt (2).
6. Push the drainage pipe with the reservoir and bracket onto the fitting (Figure 11).
7. Remove screws connecting upper and lower parts of the oil pan and replace them with M6 x 25 hex socket screws (arrows, Figure 12). Attach bracket with reservoir using M6 nut.
NOTE!
After installation, make sure there is sufficient clearance between the drainage pipe and all moving parts.
Parts Information
Part Name Part Number
Drainage pipe kit 117 200 00 52
Sealant/locker (e.g. Loctite(R) 242/Wurth(R) 242) Local purchase
In Case of Warranty
Operation: Coolant pump drainage pipe, retrofit (02-2028)
Coolant pump drainage pipe, install (02-2029) (when replacing coolant pump)