AH01.40-P-1000-06A Notes Application of Sealant to End Cover With Radial Shaft Seal

AH01.40-P-1000-06A Notes application of sealant to end cover with radial shaft seal

Component Identification:

Application of sealant to end cover
The lines drawn G, E and the arrow D mark the application of sealant.

Clean sealing surfaces, apply sealant only to the specified surfaces with a bead of 2.0 mm ± 0.5 mm.

The sealant must be applied within 10 minutes!

The silicone bead must not be spread. Only the approved silicone sealant may be used may be used.