AR03.10-P-7021-02BV Assigning A Standard Dimension Piston to A Cylinder Bore

AR03.10-P-7021-02BV Assigning a standard dimension piston to a cylinder bore

Test specifications for cylinder bore

Test specifications for cylinder bore:

Test specifications for cylinder bore:

Test specifications for cylinder bore:

Test specifications for pistons

Test specifications for pistons:

Test specifications for pistons:

Shown on engine 112:

The pistons marked with an "x" must only be installed in the cylinder bores likewise marked with 'x'.
1 The piston diameter on engines 112, 113 is stated in two tolerances. The two tolerances of the piston diameters are distinguished one from the other by the letters "x" and "(x)".
The marking is located on the top of the piston crown.

Shown on engine 112:

2 The cylinder bore diameter on engines 112, 113 is stated in two tolerances. The two tolerances of the cylinder bore diameters are distinguished one from the other by the letters "x" and "(x)".
The marking is located at the bottom right on the crankcase at the mount for the engine support.