AR68.10-P-1180E Remove/Install Trim Strip on Instrument Panel

AR68.10-P-1180E Remove/Install Trim Strip on Instrument Panel
- model 202 with CODE (956a) Sport
- model 202 with CODE (955a) Elegance
- model 202 with CODE (959a) Esprit [up to 05/31/94]
- model 208.3 [all]










Removal
1 Remove stud (3, without nut) on trim strip (1) on right side from push-in clip (5) with plastic wedge

NOTE: On some vehicles a nut was installed on the stud (3) to fit the trim strip (1) better

CAUTION: Always remove nut before disassembling

NOTE:
- For this purpose remove glove compartment and unscrew nut (8 mm) on stud through this opening.
- Replace insert clip (5) after removing trim strip (1)

2 Pull trim strip (1) toward right and then move stud (4, with nuts) out of sliding clips (6) in instrument panel (2)
3 Remove trim strip (1)

Installation
4 Position trim strip (1) in instrument panel (2) with studs (4, with nuts) in sliding clips (6) and slide to left against stop
5 Press stud (3, without nut) into push-in type clip (5) on right side and lock in place


Special Tools

Long Wedge, P/N # 115 589 03 59 00: