Restraints - Head Restraint Height Adjuster Is Inop.

DTB

Date: September 26, 2008
Order No.: P-B-91.16/94b
Supersedes: P-B-91.16/94a dated June 16, 2008
Group: 91







SUBJECT: All Model 203, 209 and 211 Vehicles
Electric Head Restraint Height Adjuster Not Functioning

If you receive customer reports in the above model vehicles that the electric head restraint height adjuster is not functioning, the printed circuit board (PCB) at the motor may have broken due to tension applied to it by the wiring harness. Fault code 9203, hall sensor of component M27m4 (Head restraint raise/lower motor) is faulty, may also be present.

1. Remove the head restraint height adjuster per WIS document AR91.29-P-1432P (203 and 209) or AR91.29-P-1432T (211).

2. Use a cable tie to secure wiring harness to strut (Figure 1, arrow)







3. Guide wiring harness behind top transverse wire (Figure 2, arrow)







4. Reinstall the head restraint height adjuster per WIS document AR91.29-P-1432P (203 and 209) or AR91.29-P-1432T (211).

Parts Information







NOTE: The following allowable labor operations should be used when submitting a warranty claim for this repair. This information has been generated on September 26, 2008. Please refer to Netstar -> Star TekInfo -> Star Time for the most current labor time allowance.

In Case of Warranty

Operation: Short test, perform (54-1011)
Power seat motor - driver headrest adjustment, replace (91-6042)
Power seat motor - front passenger headrest adjustment, replace (91-6092)