Procedures

Remove/install Spring Link, Replace Rubber Mount

Shown On Model 129:

Shown On Model 210:

CAUTION: Installation: Replace self-locking nuts

DANGER:
- Risk of fatal accident from vehicle slipping or toppling off the lift platform
- Align vehicle between the columns of the lifting platform and position the four support plates at the lifting platform support points specified by the vehicle manufacturer.

NOTE: Remove and install rear spring

Adjust roll bar switch

NOTE: Following installation.

6 Spring link

CAUTION: The rear axle shaft must be horizontal when tightening the nuts

6B Rubber bearing to spring link

NOTE: If necessary after checking, Remove/install spring link rubber mount.

6g Spring link shield
6j Remove shock absorber or spring strut at spring link
6k Torsion bar link rod
6i Remove/install guide rail at spring link
36 Frame cross-strut

118B Linkage between headlight leveling device and right-hand spring link
- Vehicles with xenon headlamps only

S83/2, S83/3 Remove/install left or right rear axle roll bar (RB) switch