Y22/6 (Variable Intake Manifold Switchover Valve): Short Circuit to Positive

Y22/6 (Variable Intake Manifold Switchover Valve) :: Short Circuit to Positive

Check Component Y22/6 (Variable Intake Manifold Switchover Valve)

Test 1 Test Actuation of Component Y22/6 (Variable Intake Manifold Switchover Valve)
Test 2 Test Current Consumption of Component Y22/6 (Variable Intake Manifold Switchover Valve)
Test 3 Test Internal Resistance of Component Y22/6 (Variable Intake Manifold Switchover Valve)


1 Test Actuation of Component Y22/6 (Variable Intake Manifold Switchover Valve)





Figure legend
- 22/1 Vacuum unit for variable intake manifold
- Y22/6 (variable intake manifold switchover valve)

Test requirements
- The vacuum system is leaktight.

Test sequence
- Run the engine for a short time and switch off again.
- Switch on ignition.
- Actuate component Y22/6 (variable intake manifold switchover valve).(Actuate with key F2.)

Specified value
- Look - The rod of the vacuum unit can be seen to operate.(See arrow)

Note: Component M4/3 (engine/AC electric suction fan) runs with an on/off ratio of 50 % during the actuations for safety reasons.

Note! Communication with ECU required.


2 Test Current Consumption of Component Y22/6 (Variable Intake Manifold Switchover Valve)

Test requirements
- Actuation is not okay.

Test sequence
- Switch off ignition.
- Connect socket box (35-pin) to component N3/10 (ME-SFI control module).
- Connect socket box (126-pin) to component N3/10 (ME-SFI control module).
- (5.7) Pin 7 of 35 <--> Pin 23 of 126 (2.14)
- Switch on ignition.

Specified value
- Amperage[0.3...0.8] A

Question
- Is the measured value okay?
Yes
The measured value is o.k.
Further possible causes of fault
- Vacuum unit for variable intake manifold
No
The measured value is not o.k.
Possible cause and remedy
- Voltage supply of component Y22/6 (variable intake manifold switchover valve)
- Wiring from control unit N3/10 (ME-SFI control module) to component Y22/6 (variable intake manifold switchover valve)
- Test internal resistance of component Y22/6 (variable intake manifold switchover valve).
- Y22/6 (variable intake manifold switchover valve)

** End of Test **


3 Test Internal Resistance of Component Y22/6 (Variable Intake Manifold Switchover Valve)

Test requirements
- Actuation is not okay.

Test sequence
- Switch off ignition.
- Detach the socket at the component Y22/6 (variable intake manifold switchover valve).
- (Y22/6) 1 <--> 2 (Y22/6)

Specified value
- Resistor[20...30]

Question
- Is the measured value okay?
Yes
The measured value is o.k.
Further possible causes of fault
- Vacuum unit for variable intake manifold
No
The measured value is not o.k.
Possible cause and remedy
- Y22/6 (variable intake manifold switchover valve)

** End of Test **