Electronic Selector Lever Codes

Version 220 Electronic Selector Lever Codes

DTC Test scope

EP1747 The brightness signal from control module A1 (Instrument cluster) is not available on the CAN bus.�

EP1750 The supply voltage of the control unit is too low (undervoltage).�

EP1860 The right rear wheel rpm signal sent from the traction system via the CAN bus is implausible.�

EP1861 The left rear wheel rpm signal sent from the traction system via the CAN bus is implausible.�

EP1876 The wheel rpms from the traction system are not available on the CAN bus.�

EP1904 The brightness signal sent from control unit A1 (Instrument cluster (KI)) via the CAN bus is implausible.�

EP1906 The stop lamp switch signal from control module N73 (EIS [EZS] control unit) is not available on the CAN bus.�

EP1910 The supply voltage of the control unit is too high (overvoltage).�

P1000 Control unit N15/5 (Electronic selector lever module control unit) is defective.�

P1832 The output stage in control module N15/5 (Electronic selector lever module control unit) has Short circuit.�

P1833 The output stage in control module N15/5 (Electronic selector lever module control unit) has Open circuit.�

P1856 Selector lever position detection has failed.�

P1875 CAN communication with other control units installed in this vehicle is not possible.�

P1911 The link between control module N15/5 (Electronic selector lever module (ESM [EWM])) and the shift gate illumination is interrupted.�

P1912 The pushbutton signals are implausible.�

P1925 Drive authorization has been refused by control module N15/5 (Electronic selector lever module (ESM [EWM])).