M16/6 (Throttle valve actuator) : Position Throttle valve (P2101)

M16/6 (Throttle valve actuator) : Position Throttle valve (P2101)


Possible cause:

- M16/6 (Throttle valve actuator)
Affected functions:

- Engine diagnosis
- Engine running

-------------------------------------------------

Test 1: Check component M16/6 (Throttle valve actuator).

1. Check component M16/6 (Throttle valve actuator).

Test 1.1: Check component M16/6 (Throttle valve actuator) using actual value.

Test 1.2: Check component M16/6m1 (Actuator motor) by means of actuation.

Test 1.3: Check internal resistance of component M16/6m1 (Actuator motor).

Test 1.4: Perform mechanical inspection of component M16/6 (Throttle valve actuator).

1.1. Check component M16/6 (Throttle valve actuator) using actual value.
Warning!Communication with ECU required.


1.2. Check component M16/6m1 (Actuator motor) by means of actuation.
Test prerequisite

- Operate engine at idling speed.
Note

- If the throttle valve angle is< 1,1°, unmetered air may be present.
Status of relevant actual value:
- Throttle valve angle:Warning! Communication with ECU required.
Move on to actuation with button F2

1.3. Check internal resistance of component M16/6m1 (Actuator motor).
Figure legend

- A -ConnectionTest cable 35-pin socket box
- 001 -Sockets of component N3/10 (ME-SFI [ME] control unit)
- 05 -35-pin socket box
- 050 -126-pin socket box
- 108 -Test cable 266 589 01 63 00
- N3/10 (ME-SFI [ME] control unit)
- II 1-63ConnectionTest cable
- III 64-126ConnectionTest cable
Warning!

- Connection A of test cable 108 may NOT be connected to connection B of the 126-pin socket box (050).
Continue to test with button F2







Test sequence

- Switch off ignition.
- Disconnect coupling M at component N3/10 (ME-SFI [ME] control unit).
- Measure resistance with multimeter between sockets (M.75) 75 and (M.74) 74 of the 126-pole socket box tester.
Specified value

- Resistor[1...10]ohms
Question

- Is the measurement value OK?


YES
The measurement value is OK.End of test

NO
The measurement value is not OK.Possible cause and remedy

- Lines between N3/10 (ME-SFI [ME] control unit) and M16/6m1 (Actuator motor)
- M16/6m1 (Actuator motor)
End of test

1.4. Perform mechanical inspection of component M16/6 (Throttle valve actuator).
Test sequence

- Switch off ignition.
- Expose component M16/6 (Throttle valve actuator).
- Slowly operate throttle flap by hand up to full load.
Specified value

- The throttle valve must not stick and must close by internal spring force.
Question

- Is the test o.k?


YES
The test is o.k..Possible cause and remedy

- N3/10 (ME-SFI [ME] control unit)
End of test

NO
The test is not o.k..Possible cause and remedy

- Check intake tract for residue and clean if necessary.If no residue is present, replace component M16/6 (Throttle valve actuator).