AR41.10-P-0100-01DA Pulling Off Rubber Mount With Grooved Ball Bearing and Front Protective Cap

AR41.10-P-0100-01DA Pulling off rubber mount with grooved ball bearing and front protective cap

Special Tools:

Component Identification:

Insert puller legs between rear protective cap (if installed) and propeller shaft intermediate bearing (see detail).

1 Pull rubber mount (7) together with grooved ball bearing and front protective cap (if installed) off the joint fork.

Protective caps are not installed at the grooved ball bearing, on either the stem or fork side on models 203, 208, 210, 170 and with models 129, 140, 202 as of 6/95.