GF82.61-P-0001-07CE Auto Pilot System (APS), Switch on and Switch Off Characteristics

GF82.61-P-0001-07CE Auto Pilot System (APS), Switch On And Switch Off Characteristics
- with CODE (525) MB Audio 50 APS radio
- with CODE (511) Audio 50 APS with DVD changer


Auto Pilot System (APS), switch-on/off characteristics, general
The APS can be switched on and off as follows:
^ Automatically by switching c. 15R on and off
^ Manually by actuating "ON" button the radio with auto-pilot system (A2/56)
^ Automatic switch-off in the event of undervoltage
^ Switch off behavior (run-on mode) when the destination has not been reached

Automatically by switching c. 15R on and off
When c. 15R is activated, (transmitter key (A8/1) turned to position 1 in electronic ignition lock control unit (N73)), the radio with autopilot system is switched on, unless it was switched on before the transmitter key was removed.

The last active audio action is started and the associated basic menu in the audio-/COMAND display (A40/8) is indicated. If the radio with auto pilot system was switched off, a warning notice is always shown with general information on using the audio system.

Manually by actuating "ON" button the radio with auto-pilot system
By actuating the "ON" button, the radio with auto-pilot system can also be switched on and off when the transmitter key is removed. If it is switched on, all audio system functions are available for t = 30 min.
Then the radio with auto-pilot system is switched off automatically.

Automatic switch-off in the event of undervoltage
If the voltage of the on-board electrical system battery (G1) is too low, a corresponding warning message appears on the audio-/ COMAND display. This represents an engine starts request. If the engine is not started, an additional warning message appears after t = 3 min. If the engine is not started within the next t = 10 s, the radio with auto-pilot system switches off the audio system.

If the on-board electrical system voltage increases, the radio with auto-pilot system does not switch back on automatically. The radio with auto-pilot system can then be switched on manually. The warning procedure then runs again, until the cause for the undervoltage is rectified.

Switch off behavior (run-on mode) when the destination has not been reached
If route guidance is activated and the destination is not reached (e.g. fueling stop), the navigation function remains activated for a max. of t = 30 min. After t = 30 to 120 min. the radio with auto-pilot system changes over the "Sleep mode". The route is re-calculated after restarting the vehicle and the navigation continued. After t = 120h a request is displayed after starting the vehicle asking whether the route should be recalculated:
- "YES" = Route is calculated again.
- "NO" = Navigation will cease.

This must be answered accordingly.