Instrument Panel Center Finish Panel

INSTRUMENT PANEL CENTER FINISH PANEL

Alignment Pin, Temperature Blend Door:

Special Tool(s)

Removal and Installation
1. Disconnect the battery.







2. Lower the glove compartment.
- Press the glove compartment release tabs inward while pulling downward on the glove compartment.







3. Disconnect the temperature control cable from the blend door shaft.
- Using the special tool, align the locator holes.
- Release the locking tab.
- Disconnect the temperature control cable.







4. Remove the instrument panel center finish panel.
- Disconnect the electrical connectors.

5. To install, reverse the removal procedure.