Torca(R) Clamp
Torca(R) ClampNOTE: Do not tighten the new Torca(R) clamp until the exhaust system has been aligned.
1. Remove the nut from the Torca(R) clamp.
2. Grind the spot weld from the Torca(R) clamp and remove the clamp.
3. Clean the uneven surface area and, using an abrasive pad, clean the Torca(R) clamp surface area of any rust on the pipe.
4. Position a new Torca(R) clamp 3-4 mm (0.12-0.16 inch) from the button slot.
5. Rotate the Torca(R) clamp until it is 83 degrees to 93 degrees from slot in the side of pipe.
6. Spot-weld the Torca(R) clamp to the pipe 180 degrees from the Torca(R) clamp hardware.
