Operation CHARM: Car repair manuals for everyone.
Home >> Mercury Truck >> 2008 >> Mountaineer RWD V8-4.6L >> Repair and Diagnosis >> Instrument Panel, Gauges and Warning Indicators >> Instrument Cluster / Carrier >> Service and Repair >> Instrument Cluster >> Instrument Cluster (IC)

Instrument Cluster (IC)

INSTRUMENT CLUSTER (IC)







Removal

NOTE: Prior to removal of the instrument cluster (IC), it is necessary to download the instrument cluster (IC) configuration information to the diagnostic tool.

1. Depower the supplemental restraint system (SRS).
2. Lower the tilt steering column to the lowest position.
3. Remove the instrument cluster (IC) finish panel.
4. Remove the 4 screws and the instrument cluster (IC).
- Disconnect the electrical connector.

Installation
1. To install, reverse the removal procedure.
2. Following installation of the instrument cluster (IC), download the module configuration information and the vehicle identification number (VIN) from the diagnostic tool into the new instrument cluster (IC).

3. NOTE: If the instrument cluster (IC) is installed new, updated, or re-configured, the instrument cluster (IC) requires a parameter reset to allow the instrument cluster (IC) and the powertrain control module (PCM) to recognize the passive anti-theft system (PATS) keys. Failure to carry out the parameter reset to the instrument cluster (IC) may result in a no start condition.

Carry out the parameter reset and key programming procedure.
pro multis · About Operation CHARM