Rear

Wheel Bearing and Wheel Hub








Removal and Installation

CAUTION: Suspension fasteners are critical parts because they affect performance of vital components and systems and their failure may result in major service expense. New parts must be installed with the same part numbers or equivalent part, if replacement is necessary. Do not use a replacement part of lesser quality or substitute design. Torque values must be used as specified during reassembly to make sure of correct retention of these parts.

1. Remove the wheel knuckle.
2. Remove the 3 brake disc shield bolts.
^ To install, tighten to 8 Nm (71 lb-inch).
3. Using the special tool and a suitable press, remove the wheel hub.





4. Remove the snap ring.
5. Using a suitable press and adapters, remove the wheel bearing.
6. To install, reverse the removal procedure.
7. Install the wheel knuckle.