Instrument Panel Finish Panel - Center, Upper

Instrument Panel Finish Panel - Center, Upper

Removal and Installation

1. NOTE: The ignition switch must be in the OFF position if disconnecting the Passenger Air Bag Deactivation (PAD) indicator electrical connector. Otherwise, a DTC will be set in the Restraints Control Module (RCM) memory and must be cleared before releasing the vehicle.

Turn the ignition OFF and wait at least 1 minute.

2. Remove the upper instrument panel center finish panel.
- Pull the upper instrument panel center finish panel outward.

- Disconnect the electrical connector.

3. To install, reverse the removal procedure.
- Make sure to align the trim panel retaining clips to the retaining clip holes in the instrument panel.