TY - Test
TY: Transmission Range Signal
TY: Introduction TY - Introduction
-------------------------------------------------
TY1 DTC P1921: CHECK FOR THE PRESENCE OF DTC P1145
Note: Diagnose and repair any transmission range (TR) sensor Key ON, engine OFF (KOEO) and Key ON, engine running (KOER) self-test DTCs before entering this pinpoint test.
Note: The transaxle control module (TCM) DTC P1921 may be set as a result of DTC P1145.
Is TCM DTC P1145 present during the self-test?
YES
DISREGARD DTC P1921 at this time and DIAGNOSE TCM DTC P1145.
GO to Pinpoint Test TU TU - Introduction.
NO
GO to TY2.
-------------------------------------------------
TY2 KOEO AND CONTINUOUS MEMORY DTC P1921: VERIFY THAT THE CONCERN IS PRESENT
Note: Clearing the TCM DTCs erases any TCM recorded freeze frame data. Make sure to record any TCM freeze frame information before proceeding any further. Refer to the scan tool instruction manual for freeze frame PID menu.
- Clear and retrieve the TCM continuous DTCs.
Is DTC P1921 present?
YES
GO to TY3.
NO
GO to TY4.
-------------------------------------------------
TY3 CHECK THE TCM SHIFT POSITION PID
- Key ON, engine OFF.
- Access the TCM and monitor the PRNDL_T PID.
- Move the gear selector lever from PARK to REVERSE, NEUTRAL, DRIVE and LOW gears.
Does the gear selector match the PRNDL_T PID in every gear?
YES
INSTALL a new transaxle assembly. REFER to Automatic Transmission/Transaxle - Electronically Controlled Continuously Variable Transmission (eCVT).
NO
GO to TY6.
-------------------------------------------------
TY4 RECREATE THE SYMPTOM USING ALL AVAILABLE DATA
Note: The vehicle may need to be driven in order to recreate the original conditions that set the DTC or caused the symptom.
- Access the freeze frame data (if available) and record the DTC conditions.
- Clear the TCM DTCs.
- Obtain information from the customer information worksheet or any other available data from the customer.
- Access the TCM and monitor the PRNDL_T PID.
- Recreate the symptom using freeze frame and customer information.
- When the symptom occurs, press trigger to begin recording. Refer to scan tool instruction manual for information on the recorder function.
Could the symptom be recreated?
YES
GO to TY5.
NO
GO to Pinpoint Test Z Z - Introduction.
-------------------------------------------------
TY5 CHECK THE TCM SHIFT POSITION PID
Note: Use the data recorded in the Pinpoint Test Step TY4.
Does the gear selector match the TCM PRNDL_T PID in every gear?
YES
INSTALL a new transaxle assembly.
REFER to Automatic Transmission/Transaxle - Electronically Controlled Continuously Variable Transmission (eCVT).
NO
GO to TY6.
-------------------------------------------------
TY6 CHECK FOR CORRECT PCM OPERATION
- Disconnect all the PCM connectors.
- Visually inspect for:
- pushed out pins
- corrosion
- Connect all the PCM connectors and make sure they seat correctly.
- Carry out the PCM self-test and verify the concern is still present.
Is the concern still present?
YES
INSTALL a new PCM.
REFER to Flash Electrically Erasable Programmable Read Only Memory (EEPROM) Flash Electrically Erasable Programmable Read Only Memory (EEPROM).
NO
The system is operating correctly at this time. The concern may have been caused by a loose or corroded connector.