Ignition Switch

Ignition Switch









Removal and Installation

NOTICE: Do not remove the ignition lock cylinder and the ignition switch at the same time or damage to the column may result.

1. Depower the Supplemental Restraint System (SRS). For additional information, refer to Air Bag Systems.

2. Remove the steering column opening trim.

3. Remove the 3 lower steering column shroud screws.

4. Remove the upper and lower steering column shrouds.

5. Disconnect the ignition switch electrical connector.

6. Remove the ignition switch by pressing the 2 tabs and pulling the ignition switch outward.

7. To install, reverse the removal procedure.

8. Repower the SRS. For additional information, refer to Air Bag Systems.