Power Running Board (PRB) Step

Power Running Board (PRB) Step

NOTE: Mountaineer shown, Explorer similar.

NOTE: RH shown, LH similar.










Removal and Installation

1. With the vehicle in NEUTRAL, position it on a hoist.

2. Extend the Power Running Board (PRB).

3. NOTE: An assistant is required to hold the PRB before removing the bracket-to-step screws.

Remove the 2 front and 2 rear bracket-to-step screws and the PRB step.
- To install, align the step approximately 5 mm (0.20 in) away from the mini-mudflap that hangs down from the front splash shield. Tighten the screws to 12 Nm (106 lb-in).





4. To install, reverse the removal procedure.