Ignition Lock: Service and Repair

Removal

1. Remove the steering wheel.
2. Remove the multi-function switch.
3. Disconnect the ignition switch electrical connector.





4. Remove the shift-lock cable mounting bracket bolt and position. the bracket and cable aside.
5. Remove the four steering column upper mounting bracket bolts and lower the column.





6. Using a hammer and chisel, make a groove in the head of each of the two column lock mounting bracket bolts.
7. Remove the bolts with a screwdriver and discard the bolts.






8. Remove the steering column lock and mounting bracket.

Installation

1. Position the steering column lock and mounting bracket and install two new bolts, tightening them only enough to hold the column lock in position.
2. With the key in the ignition, verify the operation of the column lock. If necessary, reposition the column lock until it operates properly.
3. Tighten the mounting bracket bolts until the bolt heads break off.
4. Position the steering column and install the four upper mounting bracket bolts. Tighten the bolts to 9-14 N.m (8-123 lb-in).
5. On tilt column, remove the upper mounting bracket retaining pin.
6. Position the shift-lock cable mounting bracket and install the bolt. Tighten the bolt to 4-6 Nm (37-55 lb-in).
7. Connect the ignition switch electrical connector.
8. Install the multi-function switch.
9. Install the steering wheel.
10. Inspect the shift-lock system.