Crankshaft Position Sensor: Adjustments

INITIAL TIMING

Initial timing is preset at 10~ plus or minus 2~ BTDC and is not adjustable.


PIP SENSOR

1. Install Crankshaft Sensor Gauge T89P-AH or equivalent to outside surface of one vane of shutter. Gauge is magnetic and will conform to the shape of the vane.

2. Rotate crankshaft by HAND to align shutter vane with gauge into sensor air gap. Push sensor housing inward to contact gauge and tighten screws to 22-31 lb-in. CAUTION: Over tightening can cause damage to timing sensor.

3. Rotate crankshaft by HAND to position shutter vane with gauge outside of air gap. Remove magnetic gauge.