Cruise Control Servo: Service and Repair

1. Disconnect speed control actuator cable from accelerator cable.
2. Disconnect servo wiring at (14290) wiring assembly connection, located near radiator support.
3. Raise and support vehicle, then remove left front tire and wheel assembly.
4. Remove inner fender splash shield, then lower vehicle.
5. Remove two vacuum hoses from servo assembly.
6. Remove two servo mounting bracket to body support retaining screws.
7. Remove two nuts from actuator cable cover at servo.
8. Remove cover, cable and rubber boot from servo.
9. Remove two servo to mounting bracket retaining nuts.
10. Reverse procedure to install, torque retaining nuts to 45-61 in lbs.