Cruise Control Servo Cable: Service and Repair

1. Remove air cleaner assembly.
2. Remove screw or push-pin, then disconnect speed control actuator cable from accelerator cable bracket.
3. Disconnect speed control actuator cable from the accelerator cable.
4. Remove two vacuum hoses and electrical connector from the servo assembly.
5. Remove cable tie around the actuator cable, if equipped.
6. Remove two screws/nuts from servo mounting bracket.
7. Carefully remove servo and cable assembly.
8. Remove two fasteners holding cable cover to servo.
9. Pull off cover and remove cable assembly, then remove servo mounting bracket.
10. Reverse procedure to install.