California

REMOVAL
1. Disconnect battery ground cable.
2. Disconnect the engine control sensor wiring connector at the Ignition Control Module (ICM) by lifting on the locking tab, and remove the connector.

Ignition Control Module:

3. Remove ignition control module and ignition control module bracket from front fender apron (if necessary).
4. Remove ignition control module retaining screws and remove ignition control module from ignition control module bracket.

INSTALLATION
1. Install ignition control module onto ignition control module bracket and install retaining screws. Tighten screws to 2.7-3.7 Nm (24-33 in lb).
2. Install ignition control module and ignition control module bracket onto front fender apron (if removed). Tighten retaining bolt to 4-5.6 Nm (35-50 in lb).
3. Connect engine control sensor wiring connector to the ignition control module.
4. Connect battery ground cable.