Starter Motor: Service and Repair

1. Disconnect battery ground cable.
2. Raise and support front of vehicle.
3. Remove starter shield, if equipped.
4. Disconnect starter cable and push on connector.

CAUTION: When disconnecting hard-shell connector at S-terminal, grasp the plastic shell and pull off. Do not pull on wire. Be careful to pull straight off to prevent damage to the connector and the S-terminal. If any part of the connection is damaged, replace the damaged components.

5. Remove mounting bolts and starter.

NOTE: It may be necessary to turn wheels right or left to remove starter.

6. Reverse procedure to install. Torque bolts to 15-20 ft lb.