DL13 - Check EVR Circuit Continuity

- Key "OFF".

- EGR Vacuum Regulator (EVR) solenoid disconnected.

- Disconnect Powertrain Control Module (PCM). Inspect for damaged or pushed out pins, corrosion, loose wires, etc. Service as necessary.

- Install breakout box, leave PCM disconnected.

- Measure resistance between test pin 33 at the breakout box and EVR circuit at the EVR solenoid vehicle harness connector.

- Is resistance less than 5.0 ohms?

Yes -- Go to DL14. DL14 - Check EVR Circuit For Short to Power or Ground

No -- Service open circuit. Remove breakout box. Reconnect all components. Rerun quick test. Quick Test Appendix (Detailed Testing Instructions)