Combination Switch: Service and Repair

Turn Signal and Windshield Wiper Switch






Removal

1. Disconnect battery ground cable.

2. Tilt column to lowest position and remove tilt steering column lock lever.

3. Remove ignition switch lock cylinder.

4. Remove shroud screws and remove upper steering column shroud and lower steering column shroud.

5. Remove two self-tapping screws retaining turn signal and windshield wiper switch to steering column tube casting. Disengage turn signal and windshield wiper switch from casting.

6. Disconnect the two electrical connectors.

Installation

1. Install two electrical connectors to full engagement.

2. Align turn signal and windshield wiper switch mounting holes with corresponding holes in the steering column tube casting. Install two self-tapping screws making sure to start the screws in the previously tapped holes. Tighten to 2-3 N-m (17-26 lb-in).

3. Install upper steering column shroud and lower steering column shroud with screws.

4. Install ignition switch lock cylinder.

5. Install tilt steering column lock lever.

6. Connect battery ground cable.

7. Check steering column tube and turn signal and windshield wiper switch for proper operation.