Crankshaft Main Bearing

General
Clearance
Desired ........ 0.027-0.065 mm (0.001063-0.002559 inch)
Allowable ...... 0.027-0.065 mm (0.001063-0.002559 inch)
* Wall Thickness ... 1.920-1.928 mm (0.075590-0.075905 inch)

Tightening Specifications
Main Bearing Cap Bolts





1. Tighten new bolts one through ten in two steps as follows:
Step 1 ... Tighten bolts in sequence to 37-43 Nm (28-31 ft. lbs.).
Step 2 ... Rotate bolts in sequence an additional 85-95°.
2. Tighten adjusting screws No. 11-30 in sequence to 5 Nm (44 inch lbs.).
3. Tighten adjusting screws No. 11-30 in sequence to 9-11 Nm (80-97 inch lbs.).
4. Tighten side bolts No. 21-30 in sequence to 10 Nm (7 ft. lbs.).
5. Tighten side bolts No. 21-30 in sequence to 19-23 Nm (14-17 ft. lbs.).
6. Check crankshaft end play in both directions as shown.


* For 1.27 mm (0.050 inch) undersize, add 0.635 mm (0.025 inch) to standard thickness.