Throttle Position Sensor: Service and Repair

REMOVAL
1. Disconnect the battery ground cable.
2. Remove the air cleaner outlet tube.







3. Disconnect the fuel charging wiring from the Throttle Position sensor (TP sensor).







4. Remove the throttle position sensor.
- Remove the screws.
- Remove the throttle position sensor.







INSTALLATION

CAUTION: Slide the rotary tangs of the TP sensor, rotated one-quarter turn clockwise away from their final installed position, into place over the throttle shaft blade, and then rotate the TP sensor counterclockwise only to the installed position. Failure to install the TP sensor in this manner may result in excessive idle speeds.

NOTE: The TP sensor is not adjustable.

1. Follow the removal procedure in reverse order.